Spindles
Some design changes have occurred over the decades and in some customer applications wall spindles have been used on basins to achieve more spindle height. If unsure please contact CB with a photograph and spindle dimensions for identification. Please use our Rapid Action Turning Directions diagram to specify turning direction when ordering.
The Torrens Lever style uses our Rapid Action® (1/4 Turn) spindles as standard for simple maintenance. A full explanation of the advantages of our Rapid Action® mechanism can be found in the Rapid Action (1/4 Turn) FAQ.
You may not need to replace the whole spindle, hydroseals and o-ring packs are available below.
|
-
Hydroseal DR Brass Jumper Valve
SKU: PA8032
High quality DR brass hydroseals are standard all CB Rapid Action tapware.
Hydroseals are now also standard on all of our full turn tapware.
(Please note that hydroseals are not used in flick mixers). Learn More -
O-Ring for Rapid Action Spindle (BS110) - Pack of 10
SKU: PA8004
This o-ring is for our Rapid Action spindles.
Rapid Action spindles require 2 to 3 o-rings per spindle (will vary by range & spindle type).
Packet of 10 o-rings.
Remember to grease o-rings with food grade plumbing grease when replaced. This type of grease should be available from your local plumbing supply store.
Installation & servicing instructions for Rapid Action® spindles are supplied with the tapware but are also available for download here. Learn More -
Torrens Lever Bib / Pillar Bonnet & Rapid Action Spindle
SKU: TL2503
Use the Finish Code drop-down menu on the product page to calculate the price in various metal finishes.
Torrens Lever Bib / Pillar Bonnet & Rapid Action Spindle
Specify in Order Notes if Hot or Cold Required.
Turning direction diagram available in FAQ Section.
A = 52mm
B = 25mm
Installation & servicing instructions for Rapid Action® spindles are supplied with the tapware but are also available for download here. Learn More -
Torrens Lever Wall Bonnet & Rapid Action Spindle
SKU: TL2505
Torrens Lever Wall Bonnet & Rapid Action Spindle
Specify in Order Notes if Hot or Cold Required.
Turning direction diagram available in FAQ Section.
A = 79mm
B = 44mm
(Please note this spindle is also used for the Forward Bowl Sink Set underassembly, as more height is required than the Basin/Vanity spindle).
Installation & servicing instructions for Rapid Action® spindles are supplied with the tapware but are also available for download here.
This bonnet & spindle is only supplied in Raw Brass as it is not visible when installed. Learn More -
Torrens Lever Basin & Vanity Bonnet & Rapid Action Spindle
SKU: TL2502
Torrens Lever Basin & Vanity Bonnet & Rapid Action Spindle
Specify in Order Notes if Hot or Cold Required.
Turning direction diagram available in FAQ Section.
A = 70mm
B = 37mm
Installation & servicing instructions for Rapid Action® spindles are supplied with the tapware but are also available for download here.
This bonnet & spindle is only supplied in Raw Brass as it is not visible when installed. Learn More